Life Fitness 95SE User Manual (English)

Questions and Answers:

C
Cameron CarterSep 9, 2025
Why is there no audio in my headphones on my Life Fitness Fitness Equipment?
- M
  Mr. Larry GreenSep 9, 2025
  If there's no audio to the headphones on your Life Fitness Fitness Equipment, several components could be at fault. The headphones themselves might be faulty, so replace the headphone assembly if necessary. Alternatively, the headphone jack or its cable could be faulty, so replace the headphone jack assembly or cable assembly if needed. In some cases, the computer board or interface board may be the cause, requiring their replacement if necessary.
E
erinariasAug 27, 2025
Why doesn't the display console illuminate on my Life Fitness 95SE?
- T
  Theresa AguilarAug 27, 2025
  If the display console on your Life Fitness Fitness Equipment isn’t illuminating, it could be due to a faulty or improperly positioned reed switch. Position the magnet away from the reed switch and verify continuity between pin #2 and #3, and an open connection between pin #1 and #3. Then, reposition the magnet close to the reed switch and verify an open circuit between pin #2 and #3, and continuity between pin #1 and #3. If necessary, replace the reed switch. Also, verify that the reed switch is properly positioned in relation to the magnet.
L
Luis ClarkAug 27, 2025
Why does my Life Fitness 95SE Fitness Equipment smell like it's burning?
- B
  Bradley RayAug 27, 2025
  A burning odor from your Life Fitness Fitness Equipment could be due to a couple of reasons. The alternator belt tension might be too low, requiring an adjustment. If it's a new machine, a slight odor may be emitted during the first few hours of operation as the load resistor heats up for the first few times. If the odor persists, contact customer service.
A
Alexandria SchmittAug 30, 2025
Why is the heart rate monitor not working on my Life Fitness 95SE?
- M
  Melissa HayesAug 30, 2025
  If the heart rate function is inoperative on your Life Fitness Fitness Equipment, it could stem from a few issues. There might be a faulty connection between the display console and LifePulse® sensors, so verify and repair these connections. The LifePulse® sensors themselves could be faulty, so verify their functionality and replace them if necessary. Lastly, the display console could be faulty, so verify the voltages at the display console connections, substitute a working display console, and replace it if necessary.
A
angeladayAug 31, 2025
Why does the display on my Life Fitness 95SE turn on and then off?
- R
  Rita SmithAug 31, 2025
  If the display console on your Life Fitness Fitness Equipment illuminates and then goes dark, several factors could be responsible. Insufficient battery voltage might be the cause, so verify the battery pack voltage is a minimum of 6VDC. A faulty connection between the display console and alternator control board could also be the problem, so verify these connections and voltages and repair any issues. Additionally, the display console itself or the alternator control board might be faulty, so verify voltages at the display console, substitute working components, and replace them if necessary. A faulty battery charger (SC95, 95Si, SC91, 93Si, SC85, and 90S) or AC adapter (SC91/93Si only) could also be the cause, so verify their output voltages and replace them if necessary.
C
caldwellchelseaSep 1, 2025
What causes the battery to run down quickly on Life Fitness 95SE?
- M
  Maria StarkSep 1, 2025
  If the battery runs down quickly on your Life Fitness Fitness Equipment, several factors could be contributing. A very slow stepping rate could be the issue, so try to increase your step rate and consider using an optional charger. If the Stairclimber® is frequently used by lighter users (less than 120 lbs.) for short workouts (less than 20 minutes) or for less than 2 hours per day, charge the unit overnight at least once per week. Also, ensure you're not resting the majority of your body weight on the handlebars. Finally, the battery pack itself might be faulty, so charge it overnight and verify that the battery voltage is 6VDC (+/-0.3V), replacing it if necessary.
M
Monica WoodwardSep 13, 2025
What causes an erratic heart rate display on Life Fitness 95SE Fitness Equipment?
- B
  bakerlisaSep 13, 2025
  An erratic heart rate display on Life Fitness Fitness Equipment can be caused by a couple of things. It might be due to loose LifePulse® sensors, check for this and replace the sensors if necessary. Also, the sensors could be dirty, so clean them with a solution of mild soap and water.
A
Albert PopeSep 12, 2025
What causes loose LifePulse® sensors on Life Fitness 95SE?
- S
  Sheryl RobinsonSep 12, 2025
  Loose LifePulse® sensors on Life Fitness Fitness Equipment may be due to the use of a cleaning solution containing a caustic chemical. If necessary, replace the LifePulse® sensors.
A
Andrew HoltSep 8, 2025
Why can't I change the audio level on my Life Fitness 95SE Fitness Equipment?
- L
  Lindsey SaundersSep 8, 2025
  If you're unable to change the audio level on your Life Fitness Fitness Equipment, it could be due to a faulty keypad, so perform a keypad diagnostic. Alternatively, the interface board may be faulty, and if necessary, replace the Interface board.
M
Mrs. Nancy TorresSep 6, 2025
Why is the step activity displayed inaccurately on my Life Fitness 95SE Fitness Equipment?
- M
  myersjacobSep 6, 2025
  Inaccurate displayed step activity on Life Fitness Fitness Equipment can stem from several factors. Insufficient pedal travel during operation could be the cause, so increase pedal travel. A faulty connection between the display console, alternator control board, and alternator might also be the issue, so verify and repair these connections. Additionally, faulty alternator brushes could be the problem; inspect them for equal length, cracks, or length less than ¼”, and replace if necessary. The alternator itself or the alternator control board could be faulty, so replace them if necessary, verifying connections between the display console and alternator control board and substituting a working alternator control board to test.