USE THE PULSE SENSORS
ON THE FRONT HANDLEBARS
The front handlebars (30) have built-in pulse sensors (31) which allow
pulse to be measured and displayed on the console.
1. Grasp the sensors (31) with both hands during exercise. Hold the
sensors firmly but not too tightly.
2. Your pulse will display on the console (29) after a few seconds.
CAUTION: Heart rate shown on the console may be inaccurate.
Overexertion can damage your health.
NOTE: If the sensors become damp, it may be difficult to get a pulse
reading.
NOTE: See PULSE AND TARGET HEART RATE on page 35 and PULSE
MONITORING on page 34 for detailed information. See OPERATING
INSTRUCTIONS on page 30 for information about modes, including pulse
mode.
5
26 VeloCycle User Manual Lifepro
Endurance Training Collection 27
30
31
29
31
EXERCISE BIKE PLACEMENT NOTES
In order to get in the habit of using your exercise bike every day, it’s helpful
to set it up in a convenient, comfortable location. The VeloCycle is designed
to take up a minimal amount of floor space and to look great in any room of
your home.
IMPORTANT SAFETY NOTES FOR PLACEMENT OF YOUR
VELOCYCLE
• Do not use the VeloCycle outdoors.
• Do not place the bike near water or in high-moisture environments.
• Do not place the bike near heat sources or in direct sunlight.
• Set up the VeloCycle where there will be at least two feet of clearance on
all sides of the bike.
• Only operate and store the VeloCycle on a stable, flat, clear floor.
• We recommend you place a non-slip mat or rug under the exercise bike to
protect your carpet or floor. Before beginning exercise, ensure the floor
covering will not slide during use. The floor covering should be at least
45” × 35”.
CAUTION: Take care when lifting or moving the bike. Always use proper
lifting techniques and use assistance when needed.
CAUTION: Always ensure the locking pin is properly inserted before
using, lifting, or moving the bike.
To Next Page
Loading...
