LifeSize Room Installation Guide 17
When the system does not automatically address one of these conditions, you must
manually configure the display output. You can configure the display output from the
LifeSize user interface or from the LCD interface on the LifeSize Phone connected to your
LifeSize system as described in the following sections.
Configuring Display Output from the LifeSize Interface
If your display shows the initial configuration screen but the image is distorted and unusable
or the display is blank, you must configure the display from the LifeSize Phone. Refer to
“Configuring Display Output from LifeSize Phone” on page 18.
To resolve problems with monitors from the LifeSize interface, follow these steps:
1. Ensure that no calls are in progress.
2. From the main screen, press on the remote control to access the System Menu.
3. Select Administrator Preferences and press OK.
4. Enter the administrator password and press OK.
5. Select Appearance and press OK.
6. Select Displays and press OK.
7. If you are resolving problems with a VGA monitor, select VGA for the Display Type
preference for the display you wish to manually configure.
8. If your display supports both 1280x720 and 1280x768, you can manually configure the
system to use one of these resolutions by setting the Display Resolution preference for
the display you wish to manually configure.
To Next Page
Loading...
Need help?
General
