LifeSize Room Installation Guide

LifeSize Room Installation Guide 19
IP Address Displays Invalid Value
After you complete the initial configuration, if the IP address that appears at the top of the
main screen displays an invalid value, one of the following conditions may exist:
Condition Resolution
The unit is configured to obtain an address
using DHCP and no DHCP server is
available.
Note: The DHCP client self-assigns an
address in the 169.254 class B network
and the red network symbol appears in
the status bar on the main screen.
Verify that the unit is plugged into a network that has a DHCP
server present.
Faulty Ethernet cable connection. Replace the Ethernet cable with a high quality cable.
The unit is configured to use a static IP
address, but no IP address has been
entered.
Identify and enter the necessary IP information if you disable
DHCP.
Network connection is unavailable.
A red network symbol appears in the
status bar on the main screen.
Inspect your network connection.

LifeSize Room Specifications

General

Dual Display Support	Yes
Video Standards	H.264, H.263+
Audio Standards	G.711, G.722
Connectivity	Ethernet
Remote Control	LifeSize Remote Control
Audio Features	Echo cancellation, noise reduction
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20°C to 60°C (-4°F to 140°F)
Relative Humidity	10% to 90%, non-condensing
Power Supply	100-240V AC, 50-60Hz