LifeSpan MARATHON - Troubleshooting Common Error Codes

30
inverter is loose.
3. If the problem has not been
resolved, please contact support.
4
Over Current
1. Power off the machine, wait 1
minute, then restart.
2. Make sure the load limit of the motor
has not been exceeded.
3. Make sure that the belt is properly
lubricated and in an acceptable
working condition. Check that the
roller is on normal condition.
4. If the problem has not been
resolved, please contact support.
6
Over Voltage
1. Check the voltage from the power
supply is sufficient.
2. Power off the machine, wait for 1
minute, then restart.
3. If the problem has not been
resolved, please contact support.
8
Grounding Fault
1. Power off the machine, wait for 1
minute, then restart.
2. Check the motor’s wires are well
insulated.
3. Make sure the load limit of the motor
has not been exceeded.
4. Make sure the belt is properly
lubricated and in an acceptable
working condition. Check that the
roller is in a normal working
condition.
5. If the problem has not been
resolved, please contact support.
9
Inverter Overheating
1. Ensure the system is properly
ventilated and thoroughly clean the
inverter heat sink.
2. Return the inverter tot the place of
the purchase to replace the cooling
fan. (The fan starts when the inverter
exceeds the temperatures of 50
degrees)
3. If the problem has not been
resolved, please contact support.
10
Motor Overload
1. Make sure the load limit of the motor
has not been exceeded.
2. Make sure the belt is properly
lubricated and in an acceptable
working condition. Check that the
roller is in a normal working
condition.
3. If the problem has not been
resolved, please contact support.
11
Inverter Overload
1. Make sure the load limit of the motor
has not been exceeded.
2. Make sure the belt is properly
lubricated and in an acceptable
working condition. Check that the
roller is in a normal working
condition.