Lifetech LTC1 - Charging the Battery; Charger Idle Display; Charger Type Display; System Time and Date

LIFEtech™MOD1C
Owner’s Manual
AM-HLTMC-OM
Rev AA January 2018
23
specific application and should be obtained from a network administrator for the network
being used.)
Address Jbus
Sets the Jbus address
Charging the Battery
At this point, the charger should have been set up by a qualified service person. Charging can
only begin with a battery of the proper type, capacity and voltage connected to the charger.
With the charger in wait mode (No battery connected) and without pressing the Stop/Start button,
the display will show the following information:
Charger Idle Display
Ref
Description
1
Charger type
2
Selected charge profile
3
Firmware Version
4
System time and date
5
Connect Battery
S11
3
4
2
1
5
24V 35A U1.3
IONIC