Lifetime 1270 - Step 4.1: Fill Base with Water

27
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
!%&
!*-
./(!2$7!2%2%15)2%$&/24()30!'%
SEC

4WOADULTSAREREQUIREDTOCOMPLETEASSEMBLY4OPREVENTSERIOUSINJURIESTHE
0OLESHOULDBEHELDDOWNBYONEADULTATALLTIMESWHILETHE"ASEISBEINGlLLED
/04)/."&),,).'7)4(7!4%2
a. Insert a "ASE0LUG!%& into the "ASE!*-in the hole closest to the Pole.
b. Fill the Base with cold water through the hole furthest from the Pole
until the water is just below the hole.
c. Using two adults, stand the Base up on a fl at
surface and fi nish fi lling the Base with water.
d. Add one tablespoon of chlorine bleach to the
water to prevent algae formation.
e. Insert the other Base Plug into the
hole furthest from the Pole.