12
One adult needs to hold down the Pole
while the Base is being lled.
Figure 2
Figure 1
CH
Figure 3
16
Insert the remaining 1 1/4” Base Plug (CH) into the top ll hole (Fig. 3).
Using two adults, carefully stand the system up.
Add water through the top hole in the Base until the water is
just below the top hole (Fig. 1).
Finish lling the Base with water (Fig 2).
CH
Insert one of the 1 1/4” Base Plugs (CH) into the lower hole in the
Base (Fig. 1).
1. Make sure the surface beneath the Base is smooth and free of stones, gravel
or sharp objects that could puncture the Base and cause leakage.
2. Check the Base frequently for cracks or punctures.
3. Always check the water level.
4. If the unit is to be stored without weight, tilt it forward and rest the Rim on
the ground.
TAKE THE FOLLOWING PRECAUTIONS:
To Next Page
Loading...
