TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
10
NO TOOLS OR HARDWARE REQUIRED FOR THIS PAGE
Move the cap from the end of the Support Tube (DKN) to the end of the short
protruding tube coming off the side of the Support Tube. Assemble the Net
Pole (DKO) to the Support Tube. Make sure the pins snap into place before
continuing to the next step.
SEC
2.1
Note: You will not need to use the bases for volleyball.
!
Cap
DKN
DKO
Note: To reduce the width of the Net, roll it onto the Net Pole until the desired length is reached.
!
Note: The Volleyball Net has three height settings: 90”, 78”, and 65”.
!
Push Button
DKO
90”
78”
65”
Adjust the Net to the desired height. Press the Push Buttons near the top
of the Net Pole (DKO) and slide the pole to the desired position. Make sure
the Buttons snap into place. Repeat this for the other Net Pole assembly.
SEC
2.2
To Next Page
Loading...
