TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
12
NO HARDWARE REQUIRED FOR THIS PAGE
SEC
2.5
Make sure the cord of the Guy Line (EGO) is threaded through the ring at
each end as shown. If it is not, just twist the knot on the ring two full
rotations in the same direction.
SEC
2.6
While one adult holds the Pole Assembly upright, use a Rubber Mallet to
drive the Plastic Stakes (EGN) through the loop at each end of the Guy Line
and into the ground at an angle. Then pull the rings up toward the top of
the Pole to secure the line.
EGO
Ring
EGN
To Next Page
Loading...
