10.7 How to pair the remote control transmitter and receiver
How to reset transmitter and receiver:
To reset a remote control* so it is no longer associated with the Raizer, do as follows:
1. Press the UP (↑ ) and DOWN (↓ ) buttons on the remote control* at the same
time and hold them down for approx. 5 seconds until the control LED on the
remote control* begins to flash slowly. The remote control is now in installation mode
for 2 minutes.
2. Perform the following within the 2 minutes:
Press: UP(↑ ), UP(↑ ), DOWN(↓ ), DOWN(↓ ), UP(↑ ), DOWN(↓ ), UP(↑ ), DOWN(↓ )
When the control LED starts to flash quickly, the remote control* is no longer associated with
the Raizer.
Pairing of extra remote control*
1. Ensure that there is power to the Raizer.
2. The Raizer must be switched off
The device will switch off automatically after 10 minutes without use (it will emit a
long beep before powering down).
3. Press the UP (↑ ) and DOWN (↓ ) buttons on the remote control* at the same time
and hold them down for approx. 5 seconds until the control LED on the remote
control* begins to flash slowly. The remote control* is now in installation mode for 2
minutes.
4. Within these 2 minutes switch on the lifting chair you require associated with the
remote control*. Press the up/down arrows on the side of the chair.
5. The control LED on the remote control* is associated with the lifting chair when it
stops flashing.
6. Test the system so as to ensure the pairing has been performed correctly; if not,
repeat 1-5 above.
*Supplementary equipment
To Next Page
Loading...
