12.Siren Ring Time setting(Default:3 minutes)
Press firstly, then input 4- digit password by the keypad,input instruction
code [32] on the keypad, then enter time [00~15] minutes, finally press ；
The host make a long beep, You will hear a voice prompt “setting completed”.
Operating method: Password[32][XX]
XX indicates: siren ring time, unit “minute”.
Example: Set 5 minutes of siren ring time.
Operating method: Password[32][05]
LCD display
13.Arm Time Delayed Setting(Default:30 seconds)
When press down the key of Out Arm, the host will arm according to the
delayed time after setting.
Press firstly, then input 4- digit password by the keypad,input instruction [33],
then input [00~99], press to confirm. The host makes a long beep. You will
hear a voice prompt “setting completed”.
Operating method: Password[33][XX]
XX indicates：Arm delayed time, unit: second.
Example: detailed operating of 2 seconds delayed time arm.
Operating method: Password[33][02]
LCD display:
14.Alarm Delayed Setting
Alarm time delayed setting is that the host will not alarm until delayed
time arrives.
Press firstly, then input 4- digit password by the keypad,input instruction
[34], enter zone number [00~99], and then input delayed time [00~99] seconds,
finally press to confirm. The host makes a long beep. You will hear a voice
prompt “setting completed”.
Operating method: Password[34][XX][XX]
XX indicates：Alarm delayed time, unit: second
Example: Detailed operating of 5 seconds alarm delayed time to 04 zone.
Operating method: Password[34][04][05]
LCD display:
15. Telephone Dial-up Cycle Times Setting(Default:9
Times)
Alarm dial-up cycle times are the times of dial-up from the beginning
again, if all the phone numbers are dial-up, but no answer.
To Next Page