The following is a list of tools you will need for installing the Lightning Audio
Adequate Length
Voltmeter
Wire strippers Battery post wrench
Electric hand drill w/assorted bits Wire cutters
Adequate Length-Red Power Wire Assorted connectors
Adequate Length-Remote Turn-on Wire
Adequate Length-Black Grounding Wire
Wire crimpers
This section focuses on some of the vehicle considerations for installing your new Lightning Audio amplifier Checking your
battery and present sound system, as well as pre-planning your system layout and best wiring routes will save installation
time When deciding how to lay out your new system, be sure that each component will be easily accessible for making
adjustments
Before beginning any installation, be sure to follow these simple rules
1 Be sure to carefully read and understand the instructions before attempting to install the amplifier
2 For safety,
disconnect the negative lead from the battery prior to beginning the installation
3 For easier assembly, we suggest you run all wires prior to mounting your amplifier in place
4 Route all of the RCA cables close together and away from any high current wires
5 Use high quality connectors for a reliable installation and to minimize signal or power loss
6 Think before you drill!
Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines
or electrical wiring when working on any vehicle
7 Never run wires underneath the vehicle Running the wires inside the vehicle provides the best protection
8 Avoid running wires over or through sharp edges Use rubber or plastic grommets to protect any wires routed through
metal, especially the firewall
9 ALWAYS
protect the battery and electrical system from damage with proper fusing Install a fuseholder and appro-
priate fuse on the +12V power wire within 18” (45 7 cm) of the battery terminal
10 When grounding to the chassis of the vehicle, scrape all paint from the metal to ensure a good, clean ground con-
nection Grounding connections should be as short as possible and always be connected to metal that is welded to
the main body, or chassis, of the vehicle
6
To Next Page
Loading...
