Need help?Do you have a question about the Lightning Audio S2.300 and is the answer not in the manual?
Improper wiring can damage the amplifier and vehicle. Contact dealer if unsure.
Power rating, input sensitivity, signal to noise ratio, crossover, fuse value, chassis size.
General precautions, planning, routing, drilling safety.
Power cable prep, fusing, battery terminal, ground cable prep, chassis ground.
Never mount in engine compartment; voids warranty and is not recommended.
Covers safety, planning, power, ground, signal, and speaker connections.
Safety precautions, planning, routing, drilling safety.
Power cable prep, fusing, battery terminal, ground connection.
Amplifiers not recommended for loads below 2Ω stereo and 4Ω bridged (mono).
B+, GND, REM Terminals, Input Connectors.
Speaker Output Terminals, Gain Control.
Common issues, diagnosis, and remedies.
Call for RA#, ship product with proof of purchase to the warranty repair department.
General| Channels | 2 |
|---|---|
| RMS Power at 4 Ohms | 75W x 2 |
| RMS Power at 2 Ohms | 150W x 2 |
| Bridged RMS Power at 4 Ohms | 300W x 1 |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | >90dB |
| Fuse Rating | 30A |
| Bass Boost | 0-12dB @ 45Hz |
| Input Sensitivity | 200mV - 4V |
| Crossover | Variable high-pass filter, 50Hz - 250Hz |
To Next Page