- 1 -
Strike S2.300
Strike S2.500
• Power RAting: 90w x 2 @ 4 ohms
170w x 2 @ 2ohms (less than 1% THD)
340w x 1 @ 4ohms
• Input SensitiVity: 150mV minimum
• High LeVel Input: 1V - 8V
• SignAl to Noise rAtio: Greater than 90dB
• ChAnnel SepArAtion: Greater than 55dB
• CrossoVer: 60-400Hz Variable, High/Low/ All Pass switch
• CrossoVer Slope: 12 dB/Octave
• EquAlizAtion: Remote Juice Boost,
Variable +12dB @ 50Hz (Remote included)
• amplifier Fuse VAlue: (2) 20A
• chAssis size: 10.25”W x 2.25”H x 10.0”L*
• Power RAting: 150w x 2 @ 4ohms
250w x 2 @ 2ohms (less than 1% THD)
500w x 1 @ 4ohms
• Input SensitiVity: 150mV minimum
• High LeVel Input: 1V - 8V
• SignAl to Noise rAtio: Greater than 90dB
• ChAnnel SepArAtion: Greater than 55dB
• CrossoVer: 60-400Hz Variable, High/Low/All Pass switch
• CrossoVer Slope: 12 dB/Octave
• EquAlizAtion: Remote Juice Boost
Variable +12dB @ 50Hz (Remote included)
• amplifier Fuse VAlue: (3) 20A
• chAssis size: 10.25”W x 2.25”H x 17.0”L*
SpecificAtions
• Power RAting:60w x 2 @ 4ohms
100w x 2 @ 2ohms (less than 1% THD)
200w x 1 @ 4ohms
• Input SensitiVity:150mV minimum
• High LeVel Input: 1V - 8V
• SignAl to Noise rAtio: Greater than 90dB
• ChAnnel SepArAtion: Greater than 55dB
• CrossoVer: 80Hz High/Low/All Pass switch
• CrossoVer Slope: 12dB/Octave
• EquAlizAtion: –
• amplifier Fuse VAlue: (1) 25A
• chAssis size: 10.25”W x 2.25”H x 8.5”L*
Specifications subject to change without notice
StriKe S2.200
Strike S2.250
• Power RAting: 75w x 2 @ 4ohms
115w x 2 @ 2ohms (less than 1% THD)
230w x 1 @ 4ohms
• Input SensitiVity: 150mV minimum
• High LeVel Input: 1V - 8V
• SignAl to Noise rAtio: Greater than 90dB
• ChAnnel SepArAtion: Greater than 55dB
• CrossoVer: 60-400Hz Variable, High/Low/All Pass switch
• CrossoVer Slope: 12dB/Octave
• EquAlizAtion: Juice Boost +6dB @ 50Hz (on/off switch)
• amplifier Fuse VAlue: (1) 30A
• chAssis size: 10.25”W x 2.25”H x 8.5”L*
2-ChAnnel Amplifiers
*End Cap adds 2.4” to Chassis length
To Next Page