Lightspeed 975 - Pairing your Microphone

15
Pairing your Microphone
SET-UP & OPERATION
Your system is shipped with microphones and base units pre-paired for quick and easy use.
If, for any reason, you need to pair new components, follow this pairing process:
SHAREMIKEFLEXMIKE
Audio
Input
Audio
Output
Audio
Output
Tone
Level
Push
StatusPower
975
From a powered o state, point
the IR transmitter lens toward
the 975 (for Sharemike, the
transmitter lens is located on
the back of the microphone).
Press and hold the power button
for 5 seconds until the mic 1 and
mic 2 lights start flashing, then
release the button and let the
pairing process finish.
The ”status” light on the base unit
will light up indicating the pairing
process is complete. The mic 1 or
mic 2 light on the microphone will
stay illuminated.
IR TRANSMITTER
BACK FRONT
MIC 2
POWER
MIC 1
MIC 2
MIC 1
POWER
IR TRANSMITTER
1 2 3