Lightspeed 975 - Media Connector Set Up and Operation

26
OPTIONAL COMPONENTS
Media Connector Set Up and Operation
WALL MOUNT OR DESKTOP
The Media Connector can be placed on a table surface or wall-
mounted.
• Choose a location that is convenient to the classroom audio
sources and power supply.
• It should be located 3-6 feet o of the floor to allow for good
transmission.
• Do not enclose in a metal cabinet or in a location where the signal
will be obstructed.
NOTE: The Media Connector does not require a direct line of sight
to the 975. However it functions best when no obstructions are
between the two devices.
Media Connector Set Up and Operation
DETERMINE LOCATION
Media Connector is designed to be connected to the primary media
source in the classroom, usually the computer or display panel.
CONNECT TO POWER
Connect the USB power cord to a computer. Plug the
USB cable into the USB input on the back of the Media
Connector.
or
Use the USB power adapter to plug into a wall outlet.
Audio
Input
Audio
Output
Tone
Level
Push
StatusPower
Media
Media
Connector
Connector
OR
Audio
Input
Audio
Output
Tone
Level
Push
StatusPower
Media
Media
Connector
Connector
USB CABLE USB POWER ADAPTER