7
This is a eld option. You might not use this option with your Lightstat TME. You
may add this in the eld to an existing Lightstat TME.
Mount the Remote Room Sensor on the wall 5’ to 7’ off the oor, in the area to be
controlled.
Use #18 gauge 2-conductor twisted pair cable between the Lightstat TME and the
Remote Room Sensor. Remote Room Sensors are unaffected by wire runs of up
to 500 feet.
Remote Room Sensor cables do not have polarity, either wire may be connected
to either terminal. Cables do not need to be shielded.
At the Lightstat TME end connect the 2-conductor cable to the two terminals
marked Remote Room Sensor.
Note: The Lightstat TME must be powered Off and On in order to “read” a
change of switch settings.
When using a Remote Room Sensor make sure the Remote Room Sensor
switch (#5) on the inside of the Lightstat TME is set to ON. The word REMOTE
will appear in the display.
To Next Page
Loading...
