LiGo BT - Using the Nightlight Feature; Operating the Baby Unit Nightlight

If you experience any problems, please call the Helpline on Freephone 0808 100 6554* or visit www.bt.com/producthelp
Using your BT Digital Baby Monitor & Pacifier 25
The default setting is Medium.
The default setting is Constant.
Select the lightshow brightness level using the
Parent unit
1. Press
. Lightshow is displayed, press .
2. Turn On? is displayed, press
to display
Brightness and press
.
3. Press
or to display either Low, Medium or
High and press
to select. The display will show
Saved briefly and you’ll hear a confirmation tone.
Set the lightshow timer
1. Press
. Lightshow is displayed, press .
2. Turn On? is displayed, press
until Timer is
displayed and press
.
3. Press
or to display either 5 min,
10 min, 15 min or Constant and press
to
select. The display will show Saved briefly and
you’ll hear a confirmation tone.
Adjusting the lightshow angle and focus
Use the manual controls on the Baby unit
(page 11) to tilt the lightshow to one side of the
current position.
The focus wheel should be used to obtain a clear
picture on the wall or ceiling.