10
Step 7: Test the stem and fork post stability. Once you have nished steps 1-6, the stem and fork post should feel secure and
should not move front-to-back or side-to-side. To test this, place one foot on the baseboard and apply weight to the
baseboard with that foot, and place the other foot on the ground for stability. Take hold of the handlebars with both hands and
apply pressure to the handlebars forwards and backwards. Next, apply pressure to the handlebars side-to-side. If you notice
any movement, you likely need to tighten the H6 screws. Please use the Allen Key provided in the box to do so. Be sure to
tighten them all the way (until you’re unable to turn the screws further with the Allen Key). Do not over-tighten. If there is still
movement after tightening the H6 screws, please contact customer support
Step 8: Please refer to Getting Started section on page 12
To Next Page
Loading...