9
Assembly
help.li.me/hc/requests/new
Assembly Instructions (Approx. 15 min) (See images on pages 9 and 10 below
Step 1: Remove the scooter from the box and plastic wrappin
Step 2: Place Scooter Top Stem onto the Fork Post through the Tube Collar
Step 3: Push wires inside the top stem so they are not pinched or expose
Step 4: Align the Tube Collar so the front screw holes line up with holes in the Fork Pos
• Do not disconnect any wires or remove any part
• WARNING: If you notice damage to the wires or you damage the wires during assembly, please stop assembly immediately,
do not ride the scooter, and contact customer support via our webform, available at
WARNING
Fork Post
Inner Wires
Tube Collar
Top Stem
Step 5: Insert an H6 screw tted with a washer into each of the two holes in the front of the Tube Collar. Make sure the screws
thread smoothly into the holes on the Fork Post, and be sure to tighten them all the way (until you’re unable to turn the screws
further with the Allen Key). Do not over-tighten.
Step 6: Insert an H6 screw without washers into each of the two holes on the back of the Tube Collar making sure they thread
smoothly into the holes and be sure to tighten them all the way (until you’re unable to turn the screws further with the Allen
Key). Do not over-tighten.
To Next Page
Loading...