Electrical Warnin
DO NOT attempt to disassemble the battery. This is a re risk
• Never modify the electrical system as this may result in a risk of electric shock,
electrocution, or re
• To prevent electric shock, do not immerse the charger or battery in water when
cleaning. To clean, remove the charger plug from the outlet and wipe with a dry
cloth
• Only use the charger specied by the manufacturer
• Only store is dry areas. Never store in wet conditions. Never submerge the
scooter or battery in water or other liquids
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy; if not installed and used in accordance
with the instructions, it may cause harmful interference to radio communications. There is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by powering the equipment off and on, the user is encouraged to try to correct the interference by using
any of the following measures
- Reorienting or relocating the receiving antenna
- Increasing the separation between the equipment and receiver
- Connecting the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the
dealer or an experienced radio/TV technician for help
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and with the Industry
Canada (IC) Compliance Statement. This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the device
WARNING
Safety Warnings (continued)
16
To Next Page
Loading...