Page 20
Accessory Kit Setup and Assembly
Step 3
Attach white silicone tube (10) to bottom of the “Y” connector (11) push
in securely.
Step 4
Attach the ends of the clear tubes (12) to ends of “Y” connector (11) as
shown.
Step 5
Attach a white tube connector (13) to the other end of each of the long
clear tubes (12).
Note: Once parts 10-13 (shown on this page) have been assembled,
you shouldn’t have to take them apart again. If milk gets into tubing,
remove lter, rinse with cool water, and then rinse with warm water.
Shake tubing to remove water droplets. You may ush tubing with
70% rubbing alcohol to help dry tubing. Hang over chair to dry.
9
10
11
12 13
To Next Page
Loading...
