Page 8 of 23
Before installation, de-installation or troubleshooting:
• Stop the KA20IC2.
• Disconnect the power supply
• Relieve the KA20IC2 of any loads, which may be released during the work.
Before start-up:
• Make sure that the system has been installed as instructed in this User Manual.
• Make sure that the voltage is correct before the system is connected to the mains.
(See KA20IC2 label in the appendix).
• System connection. The individual parts must be connected before connecting to
the mains.
During operation
• If the control box makes unusual noise or smells, switch off the mains voltage
immediately.
• Take care that the cables are not damaged.
• Unplug the mains cable on mobile equipment before it is moved.
• The products must only be used in an environment, that corresponds to their IP
protection.
Misc:
The actuator system has a sound level below 55dB(A) in typical applications.
Updated manuals and declarations can always be found here:
www.linak.com/HOMELINE
Electromagnetic fields (EMF):
This LINAK appliance complies will all standards regarding electromagnetic fields (EMF). If handled properly and according
to instructions in this user manual, the appliance is safe to use based on scientific evidence available today.
To Next Page
Loading...
Need help?
General
