Cleaning
The products can be cleaned as described in the following according to their IP protection stated on the
product label.
The IP code specifies the protection degree provided by the enclosures. For most products, only the
protection against ingress of water (second characteristic numeral) is specified, ingress of solid foreign
objects or dust (first characteristic numeral) is not specified and therefore replaced by the letter X in the
code.
IP protection Cleaning instructions
IPX0 Clean with a damp cloth
IPX1 Clean with a damp cloth
IPX2 Clean with a damp cloth
IPX3 Clean with a damp cloth
IPX4 Clean with a damp cloth
IPX5 Wash with a brush and water, but not water under pressure
IPX6 Wash with a brush and water. The water can be under pressure, but the system must not be
cleaned directly with a high pressure cleaner. Max. 20 oC
IPX6 Washable according to
IEC 60601-2-52
Clean by the use of wash tunnels according to IEC 60601-2-52
IPX6 Washable DURA
TM
Clean by the use of wash tunnels according to IEC 60601-2-52, extended washing cycle test
To avoid degreasing of the piston rod, the actuator should be retracted to minimum stroke and without load
before washing.
Cleaning warnings
The systems must not be sprayed directly with a high pressure cleaner.
Interconnecting cables must remain plugged in during cleaning to prevent water ingress.
Cleaning with a steam cleaner is not permitted
UV cleaning is not permitted.
To Next Page
Loading...