EasyManua.ls Logo

Linak JUMBO BAJ

Default Icon
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
JUMBO
TM
| 9
A LINAK control box, actuator and accessory component must, in the final application, be placed
where it is not exposed to any impact. This is to prevent damage if a passer-by accidentally hits it
with an object or when cleaning the floor with a broom or a mop. On a medical bed e.g. this might
be underneath the mattress support platform. If necessary to mitigate this risk, additional protection
might be required.
To avoid unintended movement, prevent foreign objects or persons from unintentionally activating a
footswitch or a hand control at any time, for instance during normal use or maintenance.
If there is visible damage on the product it should not be installed.
If the actuator system makes unusual noise or smells, switch off the mains voltage immediately and
disconnect batteries, if applicable.
The products must only be used in an environment that corresponds to their IP protection class.
The cleaners and disinfectants must not be highly alkaline or acidic (pH value 6-8). See cleaning
section.
Irrespectively of the load, the duty cycle stated on the product label must NOT be exceeded.
The control box must only be connected to the voltage stated on the label.
Systems not specified for pull must only be used in push applications.
Fastening screws and bolts must be tightened correctly.
Specifications on the product label must under no circumstances be exceeded.
NOT TO BE OPENED BY UNAUTHORISED PERSONS.
Only use the actuator within specified working limits.