Lincoln Electric Torchmate 4 00 Series Replacing Manual

2
1
Replacing the 4x00 X-Axis Motor Belt
DOC #:7301-0-US70-111318-AM-01-02
support@torchmate.com
Replacing the 4x00 X-Axis Motor Belt
Intro:
Over me, the ming belts on the 4400 and 4800 machines that join the
motor and pinion gear pulleys will wear out and require replacements. The
instrucons below explain the procedure for replacing the belts.
Tools:
 1/8 Allen Wrench
 3/16 Allen Wrench
 9/64 Allen Wrench
 5/64 Allen Wrench
 1/4 Allen Wrench
 (1) Zip Tie
Warning:
BEFORE BEGINNING, PLEASE POWER OFF ALL EQUIPMENT INCLUDING THE
ACCUMOVE CONTROLLER!*
*Irreparable damage will occur to the controller and will not be covered
under warranty if the equipment is not turned o.
Part 1:
Removing the plasma torch shown in Fig. 1.
Fig. 1: Plasma torch.

Lincoln Electric Torchmate 4 00 Series Specifications

General

Model	Torchmate 400 Series
Control System	Torchmate CAD/CAM Software
Cutting Method	Plasma
Table Size	4' x 4'
Input Voltage	115V/230V
Input Phase	Single Phase
Voltage Requirements	115V/230V
Max Material Thickness	Up to 1" (25.4 mm) depending on plasma cutter
Amperage	Dependent on plasma cutter used
Cut Capacity	Dependent on plasma cutter used
Weight	600 lbs (272 kg)
Amperage Range	Dependent on plasma cutter used
Dimensions	64" x 64" x 40" (1.6 m x 1.6 m x 1.0 m)
Duty Cycle	Dependent on plasma cutter used