6. Tighten the child safety seat tether strap
according to the manufacturer’s
instructions.
Third row center seating position
1. Route the child safety seat tether strap
over the back of the seat.
2. Locate the anchor webbing loop for the
seating position. You may need to pull
back the top of the hinged panel along
the bottom of the seatback to access the
tether anchor.
3. Clip the tether strap through the anchor
loop as shown. If the tether strap is
clipped incorrectly, the child safety seat
may not be retained properly in the event
of a crash.
4. Tighten the child safety seat tether strap
according to the manufacturer’s
instructions. If the safety seat is not
anchored properly, the risk of a child
being injured in a crash greatly increases.
If your child restraint system is equipped with
a tether strap, and the child restraint
manufacturer recommends its use, we also
recommend its use.
25
Navigator (TB5) Canada/United States of America, enUSA, First Printing
Child Safety
To Next Page
Loading...
