Lincoln Quicklub SSV - Default Chapter; Table of Contents

Subject to modifications
Owner Manual
Operating Instructions
2.2A-10001-G07
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Page 3 of 36
Table of Contets
Page
Introduction ..................................................................... 4
Explanation of Symbols Used ............................................ 4
User’s Responsibility ......................................................... 4
Environmental Protection .................................................. 4
Service .............................................................................. 4
Safety instructions.......................................................... 5
Appropriate Use ................................................................ 5
General Safety Instructions ............................................... 5
Accident Prevention Regulations ....................................... 5
Operation, Maintenance, Repair ........................................ 5
Installation ......................................................................... 6
Installation ....................................................................... 6
Tube Fittings, Screw-Type ................................................. 7
Main- and secondary Metering devices ....................... 7
Tube Fittings, Push-in Type ............................................... 7
Metering Devices ......................................................... 7
Connection of the High-pressure Hose and
the Pressure Plastic Tube ............................................ 7
Pressure Plastic Tubes and High-pressure Hoses ............ 8
Description ....................................................................... 9
Progressive Metering Devices Model SSV and SSV M ..... 9
Progressive Plunger Metering Devices – General ....... 9
Features of a Progressive Metering Device ................. 9
Page
Operation .........................................................................11
Applications ...................................................................... 11
Lubricant Distribution within the Metering Device ............ 13
Phase 1 + 2 ................................................................ 13
Phase 3 - 5 ................................................................. 14
Monitoring of the Operation ............................................. 15
System-dependent monitoring ................................... 15
Visual monitoring ........................................................ 15
Electrical monitoring (microprocessor control) ........... 16
Pressure relief valve ................................................... 16
Determining the Lubricant Output by Combining Outlets 17
Tube Fittings, Screw-Type ......................................... 17
Tube Fittings, Push-in-Type (main metering device) .. 18
Tube Fittings, Push-in-Type
(secondary metering devices) .................................... 19
Planning and Layout ...................................................... 20
Instructions for Quicklub Progressive Systems ................ 20
Troubleshooting ............................................................. 29
Technical Data ................................................................ 31
Metering Devices ............................................................. 31
Screw-Type and Push-in-Type Tube Fittings ................... 31
Lines ................................................................................ 31
Tightening torques ........................................................... 31
Dimensions ...................................................................... 32
Metering Devices Model SSV 6 to SSV 22.................. 32
Metering Devices SSV M 6 to SSV M 12 ................... 32
List of Lubricants ........................................................... 33
Further Information can be found in the following manuals:
Technical Description Quicklub - Pump 203
Technical Description for “Electronic Control Units” of pump 203:
Printed-Circuit Board 236-13857-1 - Variant H
1)
Printed-Circuit Board 236-13862-1 - Variant V10 - V13
1)
Printed-Circuit Board 236-13870-1 - Variant M 08 - M 15
1)
Printed-Circuit Board 236-13870-1 - Variant M 16 - M 23
1)
Installation Instructions
Parts Catalogue
1)
The model designation of the printed-circuit board is part of the pump model designation indicated on the pump nameplate.
Example: P 203 - 2XN - 1K6 - 24 - 1A1.10 - V10