Cables and connectors
You will also need cables to connect the
LINDY KVM IP to your equipment. The
LINDY KVM IP’s connectors are wired in
a standard manner and so you can use
standard style cables throughout. The
cabling required will depend on your
target system which may have USB, PS/2
or Sun keyboard and mouse connections
as well as DVI or VGA style video
connections. To connect a VGA analogue
style system you will need a DVI-I to VGA
analogue cable or a DVI-I to analogue
adapter.
For analogue VGA style connections, LINDY recommends:
• KVM cable
• DVI-I to analogue VGA adapter
For digital DVI style connections, LINDY recommends:
• USB cables - 2m long, one or two may be required
• DVI video cable - 2m long
For connection to older style 8-pin Sun systems, LINDY recommends:
• Sun style KVM cable
• DVI-I to analogue VGA adapter
Other cables:
• Power switch cables
• Audio cable, stereo audio jack to stereo audio jack
(note that the LINDY KVM IP does not support PS/2 to 9-pin serial adapters)
Sun style KVM cable
KVM cables
One set per connected computer
Part numbers: 33711 - 33718
(cable lengths available:
1, 2, 3, 5, 10, 15 or 20 metres)
Single unit rack brackets
Includes four screws
Part number: 39403
Double unit rack brackets
Includes twelve screws
Part number: 39404
To Next Page
Loading...
Need help?
General
