1. Amp Models - -«ÊÌÃÊLÊÌÊÃiiVÌÊiÊvÊÌiÊ«Ê`iðÊ/iÊ
ÊÜÊÃÜÊÀi`ÊÀÊ}ÀiiÊ}Û}ÊÞÕÊÌÜÊ`iÊÌÞ«iÃÊÊi>VÊ`iÊ
V>Ìi}ÀÞ°ÊÊÌiÊ}ÕÌ>ÀÊÌiÊ>`Ê8ÊVÌÀÃÊÜÊ>ÕÌ>ÌV>ÞÊLiÊÃiÌÊ
ÌÊÃÕ`Ê}Ài>ÌÊÜÌÊÌ>ÌÊ«Ê`i]ÊÃÊÞÕÊV>ÊÕÃÌÊ«>ÞtÊ7iÊÞÕÊ
turn this knob the
DisplayÊÜÊLÀiyÞÊÃÜÊÌiÊVÕÀÀiÌÞÊ>`i`Ê«Ê
`iÊ>i]Ê>}ÊÜÌÊÌiÊVÕÀÀiÌÊÃiÌÌ}ÃÊvÊÌiÊ
DRIVE, BASS, MID,
TREBLE, CH VOL and REVERBÊLðʫÊ`iÃÊ}iÌÊ«À}ÀiÃÃÛiÞÊ
heavier and distorted as you turn the model knob clockwise.
2. Tone Controls - DRIVE is like the gain knob on other amps; controlling
how much dirt or distortion you get in the sound.
BASS, MID, and
TREBLEÊ VÌÀÃÊ >ÀiÊ VÕÃÌâi`Ê vÀÊ i>VÊ «Ê `iÊ ÌÊ }ÛiÊ ÞÕÊ
«Ì>ÊÌ>ÊVÌÀ°Ê7iÊÞÕÊÌÕÀÊ>ÞÊvÊÌiÃiÊLÃ]ÊÌiÊ`ë>ÞÊ
will briefly show the current settings of the
DRIVE, BASS, MID,
TREBLE, CH VOL and REVERB knobs.
3. Reverb - >ÊÊÀiÊÀÊiÃÃÊÛÀÌÕ>ÊÀÊÀÊÌiÀÊÀiÛiÀLÊÌÞ«i°Ê7iÊ
ÌÕÀ}ÊÌiÊL]ÊÌiÊ`ë>ÞÊÜÊÃÜÊÞÕÊÌiÊVÕÀÀiÌÊÃiÌÌ}°Ê7iÊ
L>ÀÃÊ>ÀiÊ`ë>Þi`]ÊÃiiVÌÊ>ÞÊvÊÌiÊÊ,iÛiÀLÊ`iÃÊvÀÊ
Plate to
Echo by turning the PRESETSÊL°
4. Smart Control FX - -«ÊiÊvÊÌiÃiÊLÃÊÌÊ}iÌÊ}Ài>ÌÊ8°ÊImportant
Note:Ê>VÊ->ÀÌÊvviVÌÊÀÊÃÜÃt®Ê>ÃÊ>ÌiÀ>ÌiÊivviVÌÃʸLi`¸ÊÌ°Ê
7iÊL>ÀÃÊ>ÀiÊ`ë>Þi`ÊÊÌiÊ]ÊÌÕÀÊÌiÊ
PRESETS knob to select
an alternate effect for that swoosh.
FX1 picks GAIN, VARIOUS, or PITCHÊÜÌÊ>ÊÀ>}iÊvÊÃiÌÌ}ÃʸvÀÊ
ÃÕLÌiÊÌÊiÝÌÀii¸ÊvÀÊi>VÊivviVÌ°Ê7iiÛiÀÊÞÕÊÌÕÀÊÌÃÊL]ÊÌiÊ
Display shows the active effect. Turn the FX1 knob all the way down
to turn this effect off.
FX2 knob selects from a range of MOD, FILTER, or TREMOLO effects
ÜÌÊÃiÌÌ}ÃÊiÛÛ}ʸvÀÊÃÕLÌiÊÌÊiÝÌÀii¸ÊÜÌÊÌiÊÌÕÀÊvÊ>ÊL°Ê
ÃÊLivÀi]ÊÌiÊ
Display shows the current active effect which can be
selected with the
PRESETS knob as long as the bars are visible. Turn
the
FX2 knob all the way down to turn this effect off.
FX3 picks DELAY, TAPE ECHO, or SWEEP ECHO effects with
settings from low to high. Turn this knob to display the active effect,
and the
TAPÊÊy>ÃiÃÊÞÕÀÊ`i>ÞÊÌi°Ê/ÊV>}iÊÌiÊ`i>ÞÊÌi]Ê
stomp the
TAP footswitch a few times to the desired tempo. Turn the
knob all the way down to turn this effect off.
5. FX Only (Manual Mode) - 9ÕÊV>ÊVÃiÊÌÊÕÃiÊÞÕÀÊ*"ÊÎääÊ>ÃÊ
>ÊÕÌvÝÊÕÌÊÜÌÕÌÊ>``}ÊÌiÊV>À>VÌiÀÊvÊÌiÊ*"ÊÎääÊ«Ê
`i}°Ê9ÕÊ}ÌÊ«ÀiviÀÊÌÃÊÜiÊÕÃ}ÊÞÕÀÊ*"ÊÎääÊÊvÀÌÊ
of your guitar amp. Pressing the
FX ONLY button illuminates the red
Ê>`Ê}L>ÞÊ`Ã>LiÃÊ«Ê`i}°Ê Ü]ÊÞÊ
Smart FX and
REVERB will be applied to the guitar signal.
Manual Mode: Press and hold this button to bypass current presets
ÃÜÊÊÞÕÀÊ`ë>Þ°Ê ÜÊÞÕÀÊ«ÞÃV>ÊLÊ«ÃÌÃ]ÊÜiÀiÊi>VÊ
LÊÃÊÃiÌ]ÊÜÊ`iÌiÀiÊÃiÌÌ}ÃÊ>`ÊÃÕ`ðÊ7iÊÊ
Manual Mode
your
7 Segment Display will read ---°Ê-iiVÌ}ÊÀÊÃ>Û}Ê>ÞÊ«ÀiÃiÌÊÜÊ
automatically return you to
Preset mode, where all effects and settings
are loaded per preset.
6. Tap Tempo - -Ì«}ÊÌiÊTAP button a few times sets the tempo of
your
FX2 modulation and FX3 delay effects. (Remember, most time-
L>Ãi`ÊivviVÌÃÊÊ*"ÊÎääÊV>Ê>ÛiÊÌiÊ
TAP set to Control or Don’t
ControlÊÀiÊÊÌ>ÌÊÊÌiÊ`ÌÊÃiVÌt®
Press and hold
TAP to enter Tuner Mode. Your note is shown in the
Bank/Preset Display, and the Tuning meter is shown in the Main
Display.
7. Expression Pedal - The lights to the left of this pedal show whether the
pedal will operate as a
Wah effect, Volume Pedal, or (when both lights
are lit)
FX1 Pitch Glide effect. Press the toe down to change modes.
Ã]ÊÃiiÊÌiÊ>`Û>Vi`Ê}Õ`iÊvÀÊV>LÀ>ÌÊÃÌÀÕVÌðÊ
8. Bank/Preset Display - *"ÊÎääÊViÃÊ«Ài>`i`ÊÜÌÊ>ÊÕÊ
of 128 presets. Presets (
A,B,CÊ EÊ D) are stored in Banks (1-32).
This segmented display always shows the currently loaded preset or
--- when in Manual Mode°Ê7i¿ÊÌ>ÊÀiÊ>LÕÌÊ«ÀiÃiÌÃÊ>ÌiÀÊÊÌÃÊ
guide.
9. Main Display - This display shows various pages as you work the
controls.
To Next Page
Loading...
Need help?
General
