6
Loading/threading the lm - Encapsulating
Please follow the step by step guide below to correctly load your lm;
Remove the feed tray by retracting the bolt
Remove the top mandrel
Remove the safety guard
Completely unscrew the mandrel
and cap
Load the lm onto the mandrel and
make sure it is loaded with the lm
coming o the bottom of the roll
with the adhesive side up. Tighten
the screw back up with screwdriver
provided
Ret the mandrel complete with
the loaded lm
NOTE: Indents are drilled in the
mandrels to locate core holder so
top and bottom lms line up
Core holder located on mandrel
To Next Page
Loading...
