14
① Measuring 〔 〕 , Pause 〔 〕 .
②
Position of data/ all data. Able to type the position of data.
Speed and character framing while measuring (e.g. B8-PO-S1).
（*1）
③ Selected interface.
④ Selected Mode. [Mon]: Monitoring, [DTE/DCE/Sim]:Simulating.
⑤ Status of USB device port (Bright: Connected).
⑥ Status of USB host port (Bright: Connected).
（*2）
⑦ Status of SD card slot (Bright: Connected).
（*2）
⑧ Level of remained battery. 〔 〕 indicates “ USB bus power” .
⑨ Display more setting items.
⑩
Change displayed mode.
-->Normal-->Line state-->Each frame/ Translated
（*3）
--
------------------Logic analyzer<----------------
⑪ Selected data code. Change data code.
⑫ Change display. HEX ↔ Data code.
⑬ Find specic data and errors.
⑭ Start retrieval.
* 1： [B: Data length], [P: Parity (E: Even, O: Odd, N: None)], [S: Stop bit]
* 2： Become red while accessing to the storage device.
* 3： Translated display is difference by selected protocol.
Scroll data by swiping on the screen.
Swipe in upward to look older data.
Swipe in downward to look newer data.
Press [SHIFT]+[▲］or [SHIFT]+[ ］to go to next/ previous page.
Do not remove the USB ash drive and SD card while measuring and
displaying "under cleanup".
▲
① ②
③
④
⑤
⑥ ⑦ ⑧
⑭⑬⑫⑪⑩⑨
To Next Page
Loading...
