3
Power Supply and Battery
This analyzer drives by the battery or bus power from a USB port.
Charge the Battery
Lithium ion battery is charged while running it by the USB bus power.
Charging time
When turning o the power: Take about 5 hours for full charge.
When turning on the power: Take several hours for full charge.
→ Change the charging type from the system menu.
Charge the battery under the condition of 5 °C to 40 °C. If the temperature is below 5, it
cannot charge the battery.
Charge the battery full if you are not going to use it for a long term.
Replace the Battery
If the analyzer can no longer drive by the battery, or the service time after
charging becomes extremely short, replace the battery.
Remove the battery cover and replace the battery.
Battery is necessary for saving data in the storage (USB ash drive etc)when having the
power shortage. Insert the battery all the time.
Warning
＜
Notice for battery
＞
* Do not short the terminal of the battery.
* Use the battery and battery charger specied by LINEEYE.
* Do not disassemble or modify the battery.
* Do not use the analyzer near the heater or leave it in the place with high
temperature.
It can cause heat, re, explosion, electric shock, liquid spill and malfunction.
Micro USB cable
USBport
Pull the cable of
the battery to the
direction of arrow
while pushing this
part of the connecter.
Micro USB cable
USB battery charger
To Next Page
Loading...
