20
Useful Functions
ڦ Trigger Function
By this function it executes a special measurement processing ("Action") triggered
by specic conditions ("Factor") such as the occurrence of a communication error
during the measurement or reception of the specied data.
〔Factor〕
Error Communication error, break, multiprocessor bit on
Character Communication data of up to 8 characters
Line state Logic state of interface signal line and external trigger input
Timer/Counter Timer/Counter value match
Idle time Idle time exceeding the specied time
〔Action〕
Buzzer Buzzer sound
Stop measurement Stops the measurement/test (offset to stop can be specied.)
Save data
Save data before and after the trigger to the storage device
Timer control Start/stop/restart of the timer 0/1 for trigger
Counter control Count up/clear of the counter 0/1 for trigger
Trigger control Enables/disables/inverts the state of trigger condition
Transmit data
Transmits the specied character string (in MANUAL simulation)
OT2 pulse output
Outputs an L pulse of about 1 ms to external trigger terminal OT2
Press [MENU] and touch ‟Trigger" to display the current trigger settings.
The trigger number with check mark [ ] is
valid. If you check more than one, it will be
OR condition.
Touch or [SHIFT] + [0] to [3] to turn the
check mark on/o.
Touch the factor or action to be changed
and congure it.
Touch ‟Timer/Counter" settings to set
the comparison values for timer/counter
used in the trigger function.
These timers and counters are cleared at the
start of measurement, and the timer will be
stopped state.
Shortcut key
［
MENU
］
,[2]
To Next Page
Loading...
