Appendix: Linksys Software Controls
• The Linkam equipment can be controlled with either EPICS or vendor software
called Linksys, but not both simultaneously.
– The Detector Pool no longer supports the Linksys software, but some beamlines may have it
installed on their computers.
– To use the Linkam software, make sure that the EPICS IOC is not running.
• From the desktop, click Linksys32 icon
• Select “File: Connect”
Set the rate,
max/min
temperature, and
hold time here
Data capture
controls
Start and stop
temperature ramps
To Next Page
Loading...
