Need help?Do you have a question about the Linkam Scientific Instruments THMS600 and is the answer not in the manual?
General| Brand | Linkam Scientific Instruments |
|---|---|
| Model | THMS600 |
| Category | Laboratory Equipment |
| Language | English |
Inspect for damage, do not attempt user repairs, and heed voltage warnings.
Details 12-month warranty, service, and voiding conditions.
Cleaning procedures and safe handling of liquid nitrogen.
THMS600-PS pressure limits, seal integrity, PPE, and safety advice.
Read guide, follow warnings, check cables, ensure ventilation, avoid water.
Do not use outdoors, turn off if problems, only qualified personnel for servicing.
Explains caution symbols for electrical hazards and hot surfaces.
Instructions for attaching curved stage clamps to the stage base.
How to use positioning screws and locking thumbscrew for mounting.
Instructions for setting up the ECP with the THMS600 stage.
Warning about connecting LNP95 to stage when heating above 300°C.
Step-by-step guide for purging the stage using LNP95 recycled nitrogen.
Method for purging the stage using an inert gas from a cylinder.
Diagnosing problems with slow cooling rates, checking connections and tubing.
Troubleshooting why the stage will not cool down to -196°C.
Specifies pressure limits (14Bar) and temperature range for the PS model.
Information on the safety pressure release valve and its tamper warning.
Instructions for connecting the flexible nylon pressure tubing to the gas inlet.
Addresses issues with the sample holder retaining catch disengaging.
Step-by-step solution for fixing a disengaged retaining catch.
Checks that the return catch locates correctly before closing the door.
Explains how the manipulator rod transfers the sample for quench cooling.
Transferring sample from warm post to pre-cooled block after temperature.
Steps for preparing sample and moving it to the seeding point.
Slowly programming temperature to observe crystal growth from seeding point.
Instructions on how to remove the probe assembly from the stage chamber.
Steps for connecting the BNC socket and soldering wires.
Connecting probe wire and securing it with the grub screw.
How to place the probe in any orientation using its magnetic base.
How to cut the needle to the desired length using wire cutters.
Instructions on bending the needle tip once, noting Tungsten brittleness.
Using a hex key to adjust the grub screw to change the needle angle.
To Next Page
