11
Chapter 6: Installing the Driver for Windows Millennium or 98SE
Overview
10/100/1000 Gigabit Network Adapter
Chapter 6: Installing the Driver for Windows Millennium or
98SE
Overview
After physically installing the Adapter in your computer, follow these instructions to install the driver required for
Windows Millennium or 98SE. If you need to uninstall the Adapter, refer to the “Uninstalling the Adapter” section
at the end of this chapter.
Installing the Driver
1. Power on your computer. Make sure you have administrative rights on your computer; otherwise you cannot
install the driver.
2. Windows Millennium or 98SE will automatically detect the presence of the Adapter in your computer. Insert
the Driver CD into your computer’s CD-ROM drive.
3. On the first screen of the Add New Hardware Wizard, select Specify the location of the driver (Advanced).
Then click the Next button.
4. Select Search for the best driver for my device. (Recommended). Select Specify a location:.
If your computer is running Windows Millennium, enter D:\Driver\WinME in the field provided (if “D” is the
letter of your hard drive).
If your computer is running Windows 98SE, enter D:\Win98 in the field provided (if “D” is the letter of your
hard drive).
Then click the Next button.
5. After Windows has found the driver, click the Next button.
Figure 6-2: Enter Location of Driver
Figure 6-1: Add New Hardware Wizard
Figure 6-3: Driver Files Search Results
To Next Page
Loading...
Need help?
General
