Linksys LGS116P Frequently Asked Questions

14. What are the supported PoE standards?
The switch only supports IEEE 802.3af and IEEE 802.3at. Any PoE devices not
supporting these standards will not be powered ON by the switch.
15. My PoE device is not powering ON, what should I do?
If your PoE device is not powering ON, do the following:
Verify with the vendor if it supports IEEE 802.3af and IEEE 802.3at. The switch only
supports these PoE standards.
Make sure your PoE device is connected to a PoE port.
If you have several PoE devices already connected to the switch, you may have
exceeded the power budget of the switch.

Linksys LGS116P Specifications

General

Switch type	Unmanaged
Switch layer	-
Quality of Service (QoS) support	Yes
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
10G support	No
Networking standards	IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
Throughput	1.488 Mpps
MAC address table	8000 entries
Input current	1.66 A
Power consumption (typical)	11.31 W
Number of power supply units	1
Certification	FCC Class A, CE
Product color	Black
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Total Power over Ethernet (PoE) budget	80 W
Power over Ethernet plus (PoE+) ports quantity	8

Weight and Dimensions

Depth	120 mm
Width	280 mm
Height	25 mm
Weight	822 g