IMPORTANT: Only one ethernet connection must be detected at the time of setup. Once setup is
complete, you can then hardwire additional devices
Step 1:
Turn ON the Linksys RE9000 and wait for the light indicator to blink orange.
Step 2:
Using a wireless device, locate and connect to the Linksys Extender Setup Wi-Fi.
Step 3:
Once connected, open a browser and go to http://extender.linksys.com to launch setup.
NOTE: If the Linksys RE9000 has not detected a DHCP server, it defaults to its IP address,
192.168.1.1.
QUICK TIP: If you want to bypass the setup wizard, click on Manual Setup.
To Next Page
Loading...
