EasyManuals Logo

Linksys WAP11 Quick Installation

Linksys WAP11
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
A Division of Cisco Systems, Inc.
®
Model No.
Quick Installation
Model No.
Wireless
GHz
2.4
802.11b
WAP11
Access Point
Wireless-B
12
A Locate an optimum location
for the Access Point. The best
place for the Access Point is
usually at the center of your
wireless network, with line of
sight to your wireless devices.
Usually, the higher you place
the Access Point, the better the
performance will be.
B Fix the direction of the anten-
nas. Both should be perpen-
dicular to the ground and
parallel to each other.
C Connect the included Ethernet
network cable to the Access
Point. Connect the other end
of the network cable to a
switch or hub. The Access Point
will then be connected to your
wired network.
D Connect the power adapter to
the Access Point’s Power port.
Only use the power adapter
supplied with the Access Point.
Use of a different adapter may
result in product damage.
Connect the Wireless-B
D
Set up the Wireless-B Access Point
D
The Setup Wizard will take you
through all the steps necessary to
configure the Access Point, so your
wireless and wired networks will be
able to communicate and share
resources.
A Insert the Setup CD-ROM into
your PC’s CD-ROM drive. Opti-
mally, your PC should be on
your wired network.
B The Welcome screen should
appear on your monitor. If it
does not, click Start and
choose Run. In the field that
appears, enter D:\setup.exe (if
“D” is the letter of your CD-ROM
drive). Then click Setup.
C Make sure the Access Point is
connected to your wired net-
work, so you can configure the
Access Point through any PC
on your wired network. Click
Next.
D The next screen will display a
list of access points on your
network, along with the status
information for each access
point. Select the Access Point
you want to configure by click-
ing its name. Then click Yes.
NOTE: In order for all other wireless
devices to communicate with the
Access Point, those devices must be
set to infrastructure mode. If any wire-
less devices are configured as ad-hoc
mode, they WILL NOT be recognized by
the Access Point.
Package Contents
Wireless-B Access Point
Power Adapter
Setup CD-ROM with User Guide
Quick Installation Guide
Ethernet Network Cable
Registration Card
Access Point
C
B
C

Other manuals for Linksys WAP11

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys WAP11 and is the answer not in the manual?

Linksys WAP11 Specifications

General IconGeneral
BrandLinksys
ModelWAP11
CategoryWireless Access Point
LanguageEnglish

Related product manuals