Linksys WAP4400N - Page 2

PRODUCT DATA
BUSINESS SERIES
Features
Draft 802.11n wireless
networking delivers greater
throughput and extended
range, maximizing the
number of wireless clients
per access point for your
small business
Full backwards compatibility
for 802.11b and 802.11g
Easy installation and
configuration web interface
Supports WEP, WPA-PSK,
WPA2-PSK, WPA2-ENT,
WPA-ENT authentication
(802.11i ready)
Adjustable dipole antennas
with MIMO 2x3 diversity
Gigabit Ethernet LAN
interface
Supports Power over
Ethernet (PoE) or external
DC power
Supports SNMP and intuitive
web-based interface
WMM wireless QoS
support - upgradeable to
802.11e
•
•
•
•
•
•
•
•
•
Access Point with Power Over Ethernet
Specifications
Model WAP4400N
Standards Draft IEEE802.11n, IEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u,
IEEE802.3af (Power over Ethernet), 802.1x (Security Authentication),
802.11i - Ready (Security WPA2), 802.11e - Ready (Wireless QoS)
Ports Ethernet, Power
Buttons Reset
Cabling Type UTP CAT 5
LEDs Power, Ethernet, Wireless, POE
Operating System Linux
Setup/Config
WebUI Built in Web UI for easy browser-based configuration (HTTP/HTTPS)
Management
SNMP Version SNMP Version 1, 2c, 3
Event Logging Event Logging
Remote Syslog
Web F/W upgrade Firmware upgradeable through web-browser
Diags: Flash, etc. Diags: Flash, RAM, LAN, WLAN
DHCP DHCP Client
Operating Modes
Access Point Access Point Mode
Wireless
Spec/Modulation Radio and Modulation Type: 802.11b/DSSS, 11g/OFDM, 11n/OFDM
Channels Operating Channels: 11 North America,
13 Most of Europe (ETSI and Japan)
# of Internal Ant. None
# of External Ant. 3 (Omni-Directional)
Transmit Power Transmit Power (Adjustable) at Normal Temp Range:
11b - 16 dBm at 1TX, 19 dBm at 2TX; 11g - 13 dBm at 1TX, 16
dBm at 2TX; 11n - 13 dBm at 1TX, 16 dBm at 2TX
Antenna Gain in dBi 2
Receiver Sensitivity 11.n: 300Mbps at -69dbM, 11.g: 54Mbps at -73dBm,
11.b: 11Mbps at -88dBM
Security
WEP/WPA/WPA2 WEP 64bit/128bit, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENT
Access Control Wireless connection control: MAC-based
SSID Broadcast SSID Broadcast enable/disable
802.1X IEEE 802.1X support
Quality of Service
QoS 4 queues
WMM Wireless priority
General
Load Balancing
New AP detection (used with WPC4400N)
New client detection (used with WPC4400N)
Auto-channel selection