VALET
Checking the firmware version of your router
Step 1:
Access the Hotspot’s web-based setup page. To do this, launch a web browser such as Internet Explorer
or Safari. Enter your hotspot’s IP Address on the address bar, then press [Enter]. Once the login prompt
appears, enter your router’s User name and Password.
NOTE: The default IP Address of Linksys routers is “192.168.1.1”. To view instructions on how to check the
IP address of your router, click here.
IMPORTANT: The default User name and Password is “admin” but if you have used Cisco Connect to set
up your router, you may have to open the software to retrieve them. To retrieve your router User name and
Password through Cisco Connect, go to Valet Settings > Advanced Settings.
Step 2:
Once you have the setup page open, check the upper right corner of the screen for the firmware version.
To Next Page
Loading...
