Chapter 3
Advanced Configuration
23
Wireless-N Gigabit Router with Storage Link
Administration > Management
The Administration > Management screen allows the
network’s administrator to manage specific Router
functions for access and security.
Administration > Management
Router Password
Router Access
To ensure the Router’s security, you will be asked for your
password when you access the Router’s Web-based Utility.
The default password is admin.
Router Password Enter a new Password for the Router.
Re-enter to confirm Enter the Password again to confirm.
Web Access
Web Utility Access HTTP (HyperText Transport Protocol)
is the communications protocol used to connect to servers
on the World Wide Web. HTTPS uses SSL (Secured Socket
Layer) to encrypt data transmitted for higher security.
Select HTTP or HTTPS. The default selection is HTTP.
Web Utility Access via Wireless If you are using the
Router in a public domain where you are giving wireless
access to your guests, you can disable wireless access to
the Router’s web-based utility. You will only be able to
access the web-based utility via a wired connection if you
disable the setting. Keep the default, Enable, to enable
wireless access to the Router’s web-based utility, or select
Disable to disable wireless access to the utility.
Remote Access
Remote Management To access the Router remotely
from the Internet, select Enable.
Web Utility Access Select from HTTP or HTTPS
communications protocols for remote access from the
Internet.
Remote Upgrade Select Enabled to be able to upgrade
the firmware remotely from the Internet.
Allowed Remote IP Address Select Any IP Address or
manually enter an IP address to allow remote access to the
Web-based Utility from the Internet.
Remote Management Port Enter the port number that
will be open to outside access to access the Router’s Web-
based Utility. You will need to enter the Router’s password
when accessing the Router this way, as usual.
UPnP
UPnP Keep the default, Enable to enable the UPnP
feature; otherwise, select Disable.
Allow Users to Configure To use Allow Users to
Configure, select Enabled.
Allow Users to Disable Internet Access To use Allow
Users to Disable Internet Access, click Disabled.
Backup Configurations To back up the Router’s
configuration file, click this button. Then, follow the on-
screen instructions.
Restore Configurations To restore the Router’s
configuration file, click the Browse button to locate the
file, and follow the on-screen instructions. After you select
the file, click this button.
Click Save Settings to apply your changes, or click Cancel
Changes to cancel your changes. For more information,
click Help.
Administration > Log
The Router can keep logs of all traffic for your Internet
connection.
Administration > Log
Log
Log To disable the Log function, keep the default setting,
Disabled. To monitor traffic between the network and the
Internet, select Enabled.
When you wish to view the logs, click View Log.
To Next Page
Loading...
