Linsar WM800 - Water Inlet Filters

6464
CHAPTER -7: MAINTENANCE AND CLEANING OF YOUR
MACHINE (WATER INLET FILTERS)
Onthetappartofyourmachine’swaterinlethoseandatthe
endsofwaterinletvalves,therearelterstoprevententrance
ofthedirtandforeignmaterialsinthewatertothemachine.If
themachineisunabletoreceivesufcientwater
althoughyourwatertapisopened,theselters
shouldbecleaned.
•Removethewaterinlethose.
•Removetheltersfoundonthewaterinlet
valvesbyusingapincerandwashthoroughly
withabrush.
•Cleantheltersofthewaterinlethoseslocated
onthetapsidebyremovingmanuallytogether
withtheseal.
•Afteryoucleanthelters,youcantthemthe
samewayasyouhaveremoved.
CAUTION:
Filters of water inlet valves may be
clogged due to contaminated water faucet
or lack of necessary maintenance or valves
may be broken down, causing water leaking
into your machine continuously.
The breakdowns that may arise due to
these reasons are out of the scope of
warranty.