Rev: 10.20.20 Page 13 CCD-0001526
Fig. 15 Fig. 14
Manual Override - Power System
The Lippert Electronic Leveling System can be run with auxiliary power devices like electric drills, ratchet
wrenches or cordless screwdrivers. In the event of electrical or system failure, this manual method of
extending and retracting the jacks can be used. A standard handheld drill is all that is required. See the
instructions below.
1. Remove plastic cap (Fig 14).
2. Disconnect power cables on the motor.
3. Using a ½” socket, insert into auxiliary drive device, i.e. cordless or power drill. Insert socket onto
coupler found under plastic cap (Fig. 15).
4. Run drill in reverse or counterclockwise to retract jacks.
Plastic Cap
Coupler
To Next Page
Loading...
