2
lci1.com 574-537-8900 Rev: 09.17.20
Solera
®
Slide Topper
Access Kit
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002640
Introduction
The Solera Slide Topper Access Plates are being utilized
by specific OEMs for prepping the unit to make installing
the Solera Slide Topper quicker and easier.
The Solera
®
Slide Topper is a high-quality, cost-effective
way to help keep slide-outs free of dirt, leaves and debris.
The Solera
®
Slide Topper is permanently attached to the
slide-out and retracts/extends with the room. The easy-
to-install kits are designed to fit rooms from 66” to 192” in
length.
The Solera
®
Slide Topper Access Kit comes complete with
mounting hardware.
Additional information about this product can be obtained
from lci1.com/support or by using the myLCI app.
Replacement kits can be ordered from https://store.lci1.
com/ or by using the myLCI app.
The myLCI app is available for free on iTunes
®
for iPhone
®
and iPad
®
and also on Google Play
™
for Android
™
users.
iTunes
®
, iPhone
®
, and iPad
®
are registered trademarks of
Apple Inc.
Google Play
™
and Android
™
are trademarks of Google Inc.
Safety Information
Read and fully understand all instructions before installing
or operating this product.
Adhere to all safety labels.
This manual provides general installation procedures.
Many variables can change the circumstances of the
procedure, i.e., the degree of difficulty involved in the
service operation and the ability level of the individual
performing the operation.
This manual cannot begin to plot out procedures for every
possibility, but will provide the general instructions for
effectively installing the system. In the event the skill level
required is too advanced or the procedure too difficult,
a certified technician should be consulted before
performing the necessary installation. Failure to correctly
install the system may result in voiding the warranty,
inflicting injury or even death.
FAILURE TO FOLLOW THE INSTRUCTIONS
PROVIDED IN THIS MANUAL MAY RESULT IN DEATH,
SERIOUS INJURY, UNIT DAMAGE OR VOIDING OF
THE COMPONENT WARRANTY.
ALWAYS WEAR EYE PROTECTION WHEN
PERFORMING SERVICE OR MAINTENANCE TO THE
UNIT. OTHER SAFETY EQUIPMENT TO CONSIDER
WOULD BE HEARING PROTECTION, GLOVES AND
POSSIBLY A FULL FACE SHIELD, DEPENDING ON
THE NATURE OF THE SERVICE.
MOVING PARTS CAN PINCH, CRUSH OR CUT. KEEP
CLEAR AND USE CAUTION.
Resources Required
• 1-2 people, depending on task
• Cordless or electric drill or screw gun
• Appropriate drive bits
• Screwdriver
• (2) #6 x ½” hex head screws
• 1/8” Hex key wrench
• Tape measure
• Silicone sealant or butyl tape
• Silicone lubricant