Lippert Components Solera - Parts Identification; Solera Power 18 V 69 Kit, Black; Solera Power 18 V 69 Kit, White; Common Parts

3
Solera® Awning Ground Support
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 08.16 - Solera® Awning Ground Support
Note: Keep the pull strap slot clear so accessories can be
used with the Ground Support assembly installed.
4� Mark the location for the bolt at the center of the roll tube
using the Ground Support assembly bracket (Fig. 3) as a
guide.
5� Drill a 25/64” hole at the mark made on the roll tube
(Fig. 4).
6� Place the bolt through the threaded insert tool and into the
threaded insert fastener. Then place the entire assembly into
the previously drilled hole (Fig. 5).
3� Position the Ground Support assembly bracket at the center
of the roll tube (Fig. 3).
Fig�3
Fig�4
7� Tighten the bolt to set the threaded insert fastener with the
7/16” wrench while holding the threaded insert tool stationary
(Fig. 6).
Fig�5
Fig�6
Ground Support Assembly Bracket
Bolt
Threaded Insert
Tool
Threaded Insert
Tool
7/16” Wrench
Location for
Threaded Insert