4
Solera® Awning Ground Support
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 08.16 - Solera® Awning Ground Support
8� Remove the bolt and threaded insert tool (Fig. 7).
9� The roll tube will now have a threaded hole (Fig. 8).
Fig�7
10� Place the Ground Support assembly bracket over the
threaded hole. Insert the tightening knob into the threaded
hole (Fig. 9). Tighten to mount the Ground Support assembly
to the roll tube.
Fig�8
Fig�9
Fig�10
11� Loosen the adjustment knob of the Ground Support
assembly (Fig. 10) and extend the lower leg of the assembly
to the ground (Fig. 11) to support the roll tube. Re-tighten the
adjustment knob.
Tightening Knob
Ground Support
Assembly Bracket
Adjustment
Knob
To Next Page
Loading...
