5
Solera® Awning Ground Support
Aftermarket Manual
www.lippertcomponents.com (574) 537-8900 Rev: 08.16 - Solera® Awning Ground Support
Fig�11
12� At the bottom of the Ground Support assembly, hammer
the two stakes through the holes into the ground (Fig. 12) for
added stability.
Fig�12
Removal of Ground Support
1� Pull up the stakes from the end of the Ground Support
assembly (Fig. 13).
Fig�13
2� Loosen adjustment knob (Fig. 14). Slide the bottom leg into
the top leg. Re-tighten the adjustment knob.
Fig�14
3� Remove the tightening knob from the Ground Support
assembly (Fig. 15). Remove the entire assembly from the roll
tube.
Fig�15
Bottom Leg
Top Leg
Extend Lower
Leg and Tighten
Adjustment Knob
To Next Page
Loading...
